What are the vulnerable components of electronic tensile testing machines

What are the vulnerable components of electronic tensile testing machines

It has become the main equipment for material testing nowadays because it has the advantages of easy operation and high accuracy.

The electronic tensile testing machine is mainly used for tensile compression and bending tests of materials such as plastic plates, pipes, profiles, plastic films and rubber, wires and cables, waterproofing membranes, metal wires, etc. It is an ideal testing equipment for industrial and mining industries, commercial inspection and arbitration, scientific research institutions, colleges and universities, engineering quality monitoring stations, and other parts.

Every user of an electronic tensile testing machine should have a basic understanding of the machine before use, especially some vulnerable parts, including accessories, motors, sensors, sheet metal, and sheet metal. Our technical personnel will now provide a detailed introduction to the vulnerable parts of the electronic tensile testing machine.

1. Electric motor of electronic tensile testing machine: The motor controls the operation of mechanical components and is an indirect variable speed device that supplements the motor. Although the probability of the motor appearing is not very high, if it is used too frequently, once the temperature is too high, the entire machine cannot operate normally. The motor is the soul of the entire component. Due to the CPU of the computer, it is necessary to regularly check the temperature, vibration, and internal wires of the motor, and clean it regularly.

2. Sensors: Sensors are a type of electronic component. In addition to a series of problems caused by the components, the most important and long-term cause of sensor failure is the overload of the testing force. Due to the overload, a series of chain reactions such as collisions occur, which make the testing machine unable to operate. Only by replacing the sensor and recalibrating it can it work normally.

3. Accessories for electronic tensile testing machine: Accessories are mainly used to fix the sample. Due to frequent replacement of the sample during experiments, the clamping force of the sample will change with wear. In addition, due to the metal material of the component, there may be rusting, corrosion, and other phenomena during long-term use.

4. Sheet metal: Sheet metal is the outer layer of the tensile machine, which may be damaged due to frequent use or accidental scratching of the sheet metal. In this case, it is necessary to repair it in a timely manner to avoid corrosion and scrap of the sheet metal caused by impurities such as water. Common sheet metal damages include severe deformation during transportation due to bumps, collisions, and other factors.

5. Board: The electronic tensile testing machine board referred to here is not a computer board, but a board used for testing. Once the board is damaged, it can only be repurchased or requires high-tech repair, which usually results in higher costs.